[EN] Safety
12. Grounding
To plug the controller to mains only use an outlet tted with a pin tied to ground.
Do not defeat the ground pin of the outlet as it connects the controller to earth. If the local outlet is obsolete, consult
an electrician.
The product is tted with a grounding-type plug. Do not defeat the ground wire connecting the plug's female
contact to the product's chassis.
13. Plug replacement
If the AC plug on the power supply cord of this product does not match the local outlet, it must be replaced by an
appropriate one. This operation should only be performed by qualied service personnel. Verify that the cut-off
plug is withdrawn from use, as it can cause severe electrical shock if connected to an AC outlet.
14. Lightning storm
During lightning storms, disconnect the product from the mains.
Switching the product off does not disconnect it from the mains. To do this, remove the plug from the mains outlet.
15. Interconnections
When connecting the product to other equipment, mute all output channels. Carefully read the user manual of the
other equipment and follow the instructions when making the connections.
Do not connect a speaker output in parallel or series with any other amplier output.
Do not connect the speaker outputs to any other voltage source, such as a battery, mains source, or power supply,
regardless of whether the product is turned on or off.
16. Over power risks
The product is very powerful and can be potentially dangerous to both loudspeakers and humans alike.
Even reducing the gain it is still possible to reach very high output power if the input signal level is high enough.
17. Operating temperature
The product operates at a room temperature between 0 °C and +50 °C.
18. Ventilation
Openings in the product chassis are for ventilation. They prevent the product from overheating and thus ensure
reliable operation. These openings must not be blocked or covered. The product must be installed in accordance
with the instructions given in this manual.
19. Heat
Do not operate the product near any heat source, such as radiators or other devices.
20. Water and moisture
To prevent re or shock hazard, do not expose the product to rain or moisture.
Do not use the product near water. Do not operate the product while wet.
21. Interference with external objects and/or liquids
Never push objects of any kind into the product through openings as they may touch dangerous voltage points or
short out parts that could result in a re or electric shock. Never spill liquid of any kind on the product.
22. Cleaning
Unplug the product from the mains before cleaning.
Do not use liquid or aerosol cleaners. Clean only with dry cloth.
4
LA8 product information version 7.1