Slackers Slackline SLA.475EU Mode D'emploi page 3

WARNING:
The tension on the lever of the ratchet must not exceed the safety limit of 400N of force.
WARNING: The Slackline can be tensioned only by hand. Never tighten the slackline
between two cars or other means since pre-tension can rise unexpectedly.
Step 4: Copy the same steps for the teaching line. Teaching line should be set up
approximately 1.50-2m above the Slackline. The height is determined by the Slackliner's
height to reach up and hold while learning to balance.
1) To release the ratchet, pull up the vinyl coated gate inside the
Release the Ratchets:
ratchet handle and open all the way until flat. EXPECT A "POP"
2) The second release gate should open, releasing the spool and the
line tension should "pop" open with webbing releasing.
3) Continue to pull on the line till there is little tension left.
Slide the remaining line out of the ratchet.
Note: To release all gates, open ratchet flat. Webbing will be free to unwind.