Publicité
Les langues disponibles
Les langues disponibles
EN
PARAMETS
CL.E.
13
de.a.
14
IN.D.
15
se.r.
16
se.f.
17
EL.T.
18
ST.P.
19
EN.C.
20
NE.P.
21
DE.F.
22
To set the default values: 1) access the advanced programming
function; 2) select the "dEf" parameter"; 3) activate the modification
mode ("0" on display"); 4) accept the modification (press "MENU"
and hold it down). A countdown should now appear: 49,48...,1 down
to "don". Release the key when finished.
To use both colours of a two-colour LED strip, make the connections
as explained in the CTLIGHT instructions and modify parameters
FP.r. as required (setting 2 or 3).
28
DESCRIPTION
Clearance. Allows to stop before the fully open position: it
is useful to avoid mechanical stress during opening.
Hold-to-run
0 = off
1 = on
0 = deactivated
1 = gate open light ON/OFF
2 = gate open light proportional
- Slow flashing with gate opening
- Quick flashing with gate closing
- Steady light if gate open
- 2 flashes + pause with gate stationary (position other than
closed)
3 = Electric lock
4 = Magnetic electric lock function with output active when
gate/door is closed
N.B. interface with an external relay with 24 Vdc winding. To
activate this function, the pre-flash must be enabled at the
recommended value of 1 sec (tP.r. ≠ 0)
5 = LED strip for gate open light (MODE 1)
- steady light when open and closed
- flashing light in all other positions
6 = LED strip for gate open light (MODE 2)
- gate closed steady red
- gate open LEDs off
flashing red in all other positions
Service interval cycle threshold.
(0 = off)
Enabling of continuous flashing indicating
service required with se.r. ≠ 0 (only active with gate
closed).
0 = off
1 = on
Electric lock activation time in seconds
High-speed motor start-up.
0 = on
1 = off
1 = Off (use of virtual encoder)
2 = On (use of motor's physical encoder)
1 to 10 pulses per revolution of the physical encoder
0 = Restore of factory settings for sliding gate motor
SC4224
1 = Restore of factory settings for sliding gate motor
SUN4224
2 = Restore of factory settings for sliding gate motor
SUN7224, SC7224
3 = Restore of factory settings for sliding gate motor
SUN11224, SC11224
4 = Factory setting restore for 4/6 mt barrier and up-and-
over door
5 = Factory setting restore for 8 mt barrier
DEFAULT
0
0
0
10
0
4
0
1
4
0
To use just one colour of a LED strip, make the connections as ex-
plained in the CTLIGHT instructions and modify parameter IN.D. as
required (setting 5 or 6); parameter FP.r. cannot be set on 2 or 3.
MIN
MAX
UNIT
TYPE
0
30
%
BA/OH
SL/BA/
0
1
SL/BA/
0
6
x 1000
SL/BA/
0
200
cycles
SL/BA/
0
1
SL/BA/
1
10
s
SL/BA/
0
1
SL/BA/
1
2
SL/BA/
1
10
SL/BA/
0
5
OH
OH
OH
OH
OH
OH
OH
OH
OH
Publicité
