Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
UNPACKING. PRODUCT CONTENTS
Carefully preserve the packaging of the EFT930.
It must be re-used whenever the terminal is shipped.
Packaging contains:
•
PORTABLE itself, equipped with:
- its battery pack not connected,
- its paper roll;
•
Base receiving the PORTABLE;
•
Detachable power supply unit;
(the power supply unit delivered with your terminal is specially designed for it. Do not use any other
power supply.)
The use of a power supply having apparently similar voltage/current characteristics may, in spite of it, damage
your terminal;
•
Telephone cable;
•
Installation manual.
5.
BATTERY COVER FLAP
The battery cover flap is located under the portable.
Caution :
Switch off the machine before opening the cover.
5.1.
OPENING
• Turn the PORTABLE over on the table with the bottom side
facing up (figure opposite).
• Unclip the cover flap by pushing on the clips with your nails in
the direction of the arrow 1 as shown opposite.
• Lift the cover flap on the clips side (arrow 2), disengage the
two rear limiting tabs from underneath the terminal housing
and remove the cover flap.
5.2.
CLOSING
To close up the device, carry out the above operations in the reverse order.
• Engage the two rear limiting tabs of the flap cover under the terminal housing;
• Fold cover downwards to clip it on.
If a SAM stops the cover flap from closing, check the direction of its insertion.
• Make sure the clips are totally engaged under the housing by pushing them manually.
Page 32 / 52
INSTALLATION GUIDE
3 000 068 637 éd07 / 712
Publicité
Chapitres
Table des Matières
