Secondary Smart Card Reader; Installation; Installing Eft930 On Its Base - Sagem Monetel EFT930 Livret D'installation

10. SECONDARY SMART CARD READER

The secondary smart card reader is also called "CAM2 reader".
To gain access to the secondary smart card reader, open the CAM2 cover flap.
Caution :
Switch off the machine before opening the cover.
To insert a smart card into the CAM2 reader:
• Open the CAM2 cover flap.
• Position the smart card with the chip in the position shown in figure
opposite:
- chip forward, but not visible (facing down)
- magnetic stripe visible (facing up).
• Insert the card fully home into the slot.
• Close the CAM2 cover flap.
To remove a smart card from the CAM2 reader:
• Open the CAM2 cover flap.
• Withdraw the smart card
• Close the CAM2 cover flap.

11. INSTALLATION

11.1. INSTALLING EFT930 ON ITS BASE

Place the EFT930 between the flanges on its base
so that the contacts of the EFT930 engage on the
contacts provided on the base (figure opposite).
Page 35 / 52
INSTALLATION GUIDE
3 000 068 637 éd07 / 712