Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11.4.
CONNECTING THE BATTERY
The battery pack is contained in the packaging carton.
On a new device, the battery pack is not connected.
1-
Turn the PORTABLE over on the table with the bottom
side facing up and remove the cover flap (See §" Battery
cover flap")
2- Locate the battery pack connector foolproofing and the
board connector located under the battery compartment
(figure 1).
3- Plug the battery pack connector on the board according
to the connector locating system and the wire colors
(figure 1). Feel the locking.
4- Place the battery pack in its compartment (figure 2).
5- Close the battery compartment cover flap.
11.5.
CHARGING THE BATTERY
When is the battery to be charged?
•
On initial start up, charge the battery for 16 hours under the environmental conditions stated above.
•
When used daily the PORTABLE will recharge its batteries each time it is placed on its base.
Charging is automatic.
A completly discharged battery requires 8 hours for a complete recharge.
Where is the battery to be charged?
•
The environment in which the charge takes place influences battery lifetime and autonomy (number of
transactions out of base).
The optimal conditions are as follows:
-
charging away from any external heat source (radiator, sun, enclosed area...);
the optimal temperature is between +15° C and +25° C.
-
fig.1
Page 43 / 52
INSTALLATION GUIDE
= red wire
fig.2
3 000 068 637 éd07 / 712
Publicité
Chapitres
Table des Matières
