Unpacking. Product Contents; Installing The Cad30 Uxr - Sagem Monetel CAD30 UxR Notice D'installation

2. UNPACKING. PRODUCT CONTENTS

Carefully preserve the packaging of the CAD30 UxR.
It must be re-used whenever the terminal is shipped.

3. INSTALLING THE CAD30 UXR

Reminder of Safety Instructions:
Select an electrical power supply outlet that corresponds to the general safety requirements listed in section 1
of this document.
COM0
USB S/ COM1
Alim / MDB
USB HA /
USB HB
CAD30 UCR connections
COM0 = serial link (Local Loading Tool...)
USB S = Universal Serial Bus function
nd
COM 1 = 2 serial link (optional)
USB Host A = Universal Serial Bus host (CAD30 UPP)
CAD30 USR connections
COM 0 = serial link (Local Loading Tool...)
The other connections of the CAD30USR are inecffective.
Make the following connections:
• If your terminal is equipped with the CAD30 UPP PIN-pad accessory (see description in appendix), connect
it to port USB Host.
• Connect cord to power supply
Plugs COM, USB, CLESS, Leds : Since these links are SELV (safety extra low voltage) circuits, they MUST be
interconnected to units which have interfaces powered by the same type of circuits.
Connecting is to be made when the terminal is off.
nd
USB Host B = 2
CLESS = contactless Antenna
Leds = 4 leds connector
µSDcard = micro SDcard
USB Device = Universal Serial Bus function and
Power
18/28
INSTALLATION GUIDE
µSDcard
Cless Antenna
universal serial bus host
6000004316 R11 000 02/825
leds