De-)Installation Of Sam3 And Sam4 (Or Sim) Modules; De-)Installation Of Mmc Or Sdcard - Sagem Monetel EFT930 Livret D'installation

8. (DE-)INSTALLATION OF SAM3 AND SAM4 (OR SIM)
MODULES
The SAM3 and SAM4 (or SIM) modules are installed under the CAM2 cover flap.
The location 4 may be used by a SAM or a SIM.
Caution :
Switch off the machine before opening the cover.
• Open the CAM2 cover flap (See § "CAM2 cover flap"):
you can read the location mark of SAM3 and SAM4 engraved in the
lower housing.
• When introducing a SAM in its slot, be sure to put the cut corner as
indicated on the figure opposite.
The position of the cut corner is also engraved on the lower housing.
• Close the flap cover.
9.

(DE-)INSTALLATION OF MMC OR SDCARD

To gain access to the MMC or to the SDCARD connector, open the CAM2 cover flap.
Caution:
Switch off the machine before opening the cover.
To install a MMC or a SDCARD (figure above):
• Open the CAM2 cover flap.
• Insert the MMC or a SDCARD fully home into the connector slot shown by the arrow in the figure above. Be
sure to put the cut corner as indicated on the figure above.
• Close the CAM2 cover flap.
To remove a MMC or a SDCARD:
• Open the CAM2 cover flap.
• Withdraw the MMC or a SDCARD.
• Close the CAM2 cover flap.
Page 34 / 52
INSTALLATION GUIDE
SAM4
MMC or SDCARD
3 000 068 637 éd07 / 712
SAM3