Grizzly Tools ERM 1434-3 Stow Traduction De La Notice D'utilisation Originale page 68

GB
Trouble Shooting
Problem
Equipment does
not start
Motor stops
Result unsatis-
factory or motor
labours
Blade fails to turn
Strange noises,
rattling or vibra-
tions
Replacement parts/Accessories
Spare parts and accessories can be obtained at
If you have any other questions, contact the "Service-Center (see "Sercice-Center").
68
Possible Cause
Power is off
Defective start lever (
release button (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 19) blunt
Blade area blocked
Blade ( 19) assembled in-
correctly
Blade ( 19) blocked by grass Remove the grass
Blade screw ( 20) loose
Blade screw ( 20) loose
Blade ( 19) damaged
www.grizzly-service.eu
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
2) or
16)
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Remove the foreign object
Set a higher cut height
Have the blade sharpened or re-
place it
Clean the equipment
Install the blade correctly
Tighten the blade screw
Tighten the blade screw
Replace the blade