Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The scanner doesn't react.
The scanner doesn't capture
any RFID tags.
The scanner doesn't capture
any bar codes.
No Wi-Fi connection.
No connection to the mobile
network.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
10 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
Note
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by taking the following
measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to a power outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced TV/radio technician for assistance.
Note
Changes or modifications not expressly approved by Hilti may restrict the user's authorization to
operate the equipment.
This device is in compliance with paragraph 15 of the FCC Regulations RSS-210 of the IC Regulations.
Operation is subject to the following two conditions:
•
This device shall cause no harmful interference.
•
This device must accept any interference received, including interference that may cause undesired
operation.
Possible cause
The scanner is in standby mode or
is switched off.
Software error.
The RFID tag is damaged.
The RFID tags are incompatible.
The bar code is dirty or damaged.
Wi-Fi has not been set up.
No network reception.
No SIM card has been inserted or
the mobile network has not been
set up.
No network reception.
Action to be taken
▶ Press the on/off/standby button
briefly.
▶ Press and hold the reset
button and then press the
on/off/standby button.
▶ Replace the RFID tag.
▶ Use compatible tags from Hilti.
▶ Replace the bar code.
▶ Configure the Wi-Fi settings.
→ page 15
▶ Change your location.
▶ Configure the SIM card.
→ page 15
▶ Change your location.
17
Publicité
