Hilti AI S1/4 Mode D'emploi Original page 22

5.6 Software installation
Installation of the most up-to-date version of the Hilti applications for the device will be suggested
automatically as soon as the device is connected to the Internet. The corresponding symbol will appear in
the status bar on the screen. If this does not happen within 2-3 minutes, please proceed as follows:
▶ Check the Internet connection.
▶ Restart the device.
▶ Contact Hilti Service if necessary.
6 Care and maintenance
6.1 Care
6.1.1 Cleaning and drying
▶ Clean the device with a clean, soft cloth. If necessary, moisten the cloth slightly with pure alcohol or a
little water.
Note
Use only alcohol or water for cleaning. Other liquids may damage the plastic parts.
6.2 Maintenance
▶ To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com.
7 Transport and storage
7.1 Transport
CAUTION
Risk of injury! A defective battery may cause chemical burns (contact with caustic substances) and
damage to the equipment.
▶ Remove the battery before storing or transporting the device.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting or shipping your equipment.
▶ Before transporting the device it is recommended that the grip unit is detached from the scanner.
7.2 Storage
▶ Do not put the device into storage when wet.
▶ Clean and dry the device, its case and accessories before storing.
▶ Avoid operating and storing the equipment where it is exposed to high air humidity. This increases life
expectancy.
▶ Before storing the device it is recommended that the grip unit is detached from the scanner.
▶ After long periods of storage or transport, check the device for correct operation before use.
▶ Observe the temperature limits when storing your equipment. This is particularly important in extreme
temperature conditions and if the equipment is kept inside a motor vehicle.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The scanner can't be started.
The battery becomes dis-
charged after a short period
of use.
16
Possible cause
The battery in the scanner and/or
grip unit is inadequately charged.
The battery is old or defective, or
the maximum number of charging
cycles has been exceeded.
Action to be taken
▶ Connect the charging adapter.
▶ See "Batteries" → page 13.
▶ Replace the battery.