Hilti AI S1/4 Mode D'emploi Original page 19

3.5 Items supplied
AI S1/4 scanner, AI E10 grip unit, AI E20 battery for the scanner, AI E21 battery for the grip unit, AI E30
charging adapter, PDA 60 wrist strap, operating instructions.
Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
3.6 Batteries
Note
In order to ensure maximum battery lifespan, charge the batteries at room temperature. Avoid charging
the batteries at temperatures outside the 0 to 45°C range.
The system is powered by a battery in the scanner and a battery in the grip unit. The battery in the grip unit
powers only the RFID reader unit. The battery status indicator in Android and the status LED indicate only
the status of the scanner battery. Both batteries are charged together using the charging adapter supplied.
When the batteries are fully discharged, charging may take up to 10 hours.
3.7 LEDs for scanner battery status, mobile network and Wi-Fi
3.7.1 Scanner battery
Status
Lights up red
Flashing red light
3.7.2 Mobile networks LED
Status
Lights blue
LED off
3.7.3 LED for Wi-Fi
Status
Lights blue
LED off
4 Technical data
4.1 Device
Display
Operating system
Protection class
Camera
Weight with batteries
Weight with batteries
Bar code scanner
4.2 RFID reader unit
Frequency range (UHF ETSI)
Frequency range (UHF FCC)
Range
Meaning
• Batteries are charging
• Scanner battery low state of charge
Meaning
• Connected to network/Wi-Fi
• Not connected
Meaning
• Connected to Wi-Fi
• Not connected
4 inch WVGA TFT LCD, 480 x 800 pixels
Based on Android
IP 54 dust and water spray protection as per
IEC 60529
CMOS, 5.0 megapixels, autofocus and flash
600 g
(21.2 oz)
230 g
(8.1 oz)
2D imager
865 MHz ... 868 MHz
902 MHz ... 928 MHz
0 m ... 6 m
(0 ft ... 19 ft - 10 in)
13