FLAEM RespirAir Mode D'emploi page 5

from the nebulizer and dry it using the device's compressor fan; this operation will prevent
mold from forming inside the tube.
HOW TO USE THE "RF7 DUAL SPEED PLUS" NEBULIZER WITH SPEED SELECTOR AND
VALVE SYSTEM
Professional and fast, this device is suitable for administering all types
of medications, including more expensive ones, even in patients with
chronic diseases. The geometry of the internal lines of the RF7 Dual Speed
Plus nebulizer ensures the ideal granulometry for active treatment all the
way down to the lower respiratory tract.
To speed up the inhalation therapy, move the speed selector button
(C1.4) by pressing on MAX with your finger.
For a more effective inhalation therapy, press on the opposite side of the
word Max located on the speed selector button (C1.4); this allows you to
inhale an optimal amount of the medication and reduces dispersion of
the medication into the surrounding environment to a minimum thanks
to the valve system provided in the nebulizer, mouthpiece, and mask.
SOFTTOUCH MASK
Soft
biocompatible
material
Dispersion
Limiting Device
During the inspiratory phase, the tab,
acting as a Dispersion Limiting Device,
bends inwards towards the mask
CLEANING, SANITISATION, DISINFECTION, STERILISATION
Switch off the device before any cleaning procedure and unplug the power cable from the socket.
DEVICE AND TUBING EXTERIOR
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any sort).
ACCESSORIES
Open the nebuliser by turning the upper part (C1.3) anticlockwise, remove the nozzle (C1.2)
and the speed selector (C1.4) from the upper part (C1.3) as shown in the "Assembly diagram"
in point C1.
Then proceed according to the following instructions.
CLEANING AT HOME - SANITISATION AND DISINFECTION
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one of the
methods described below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 under potable hot water
(approximately 40°C) with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 in the dishwasher with a hot
cycle.
method C: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 by immersing them in a
solution of 50% water and 50% white vinegar, then rinse thoroughly under potable hot water
(approximately 40°C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION
paragraph.
SoftTouch masks have an outer edge made of soft
biocompatible material that ensures excellent adherence to
the face, and is also equipped with an innovative Dispersion
Limiting Device. These distinctive elements that distinguish it
allow greater sedimentation of medication in the patient and
also limit dispersion.
During the expiratory phase, the
tab, acting as a Dispersion Limiting
Device, bends outwards from the
mask.
3
MAX