Télécharger Imprimer la page

Russell Hobbs 18623-56 Mode D'emploi page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
C MAKING ESPRESSO
31 Put one cup under both nozzles on the filter holder, or, for two cups, put one cup under each
nozzle.
32 Wait till the thermostat light goes off.
33 Set the steam control to W.
34 You'll hear the pump operating, and coffee will come out of the nozzles.
35 Watch the level in the cup(s).
36 Set the steam control to /.
37 This will stop the pump.
, Stop the pump just before the cups are filled to the level you want (25-30ml per shot), as the
liquid trapped in the filter will still have to come out
38 If you're making cappuccino, go to CAPPUCCINO.
C MORE?
39 Move the filter holder handle left, till it reaches the front left corner of the appliance, then
lower the filter holder from the brewing head.
40 Empty the filter.
41 Wait till they cool, then prise the filter out of the filter holder.
42 Clean them with fresh, clean water.
43 Check the reservoir, and top up as necessary.
44 Jump to point 6.
C FINISHED?
45 Move the switch to 0.
46 Unplug the appliance.
C CAPPUCCINO
47 Cappuccino is espresso with a frothy milk top.
48 You'll need a mug containing cold milk, and a cup to collect drips.
49 To allow room for the froth, don't fill the mug more than two thirds full.
50 Ideally, the mug should be tall and narrow, as the milk must be deep enough to cover the end
of the frother without it hitting the bottom of the mug.
51 We've found that semi-skimmed milk gives better results than whole milk. You'll need to
experiment to find which type works best for you in your area.
52 Don't try to make too much froth at one time. Too much steam will flatten the milk, leaving
you with nothing but hot, watery milk.
C FROTHING
53 Do the frothing immediately you have made your coffee, while the appliance is still hot.
54 Swing the frother round so it's clear of the drip tray.
55 Bring the mug containing the milk up to the frother and hold it so that the end of the frother
is just under the surface of the milk.
56 Move the frother control to S.
57 Set the steam control to Sa.
58 Steam will issue from the frother.
59 Move the jug up and down slightly, keeping the end of the frother just below the surface of
the milk.
60 Don't lift the end of the frother out of the milk, or it'll spatter.
61 Carry on till you have as much froth as you need.
62 Set the steam control to /.
63 Swing the frother back over the drip tray.
64 Spoon the froth on top of the cup(s) of espresso.
4

Publicité

loading