Brüel & Kjaer Vibro ds822 Serie Manuel page 53

4.3.1 Connecting and disconnecting plug connections
The connector ends of the displacement sensor and the extension cable feature self-latching
plug connections. They are plugged together, and not joined by a screw connection.
To assemble, observe the following order:
1. Hold one of both plug connector
2. Push both plug connectors together until they audibly click into place.
To disconnect, observe the following order:
1. Hold one of both plug connector
2. Pull on the silver serrated part of the plug
4.3.2 Connection via extension cable
1. Connect the extension cable with the integrated cable of the displacement sensor.
2. Connect the extension cable to the driver.
4.3.3 Direct connection
Connect the displacement sensor directly to the driver.

© Brüel & Kjær Vibro C105070.001 / V04

Technical alterations reserved!
ends
in each hand.
ends
in each hand.
to disconnect the connection.

EN
Page 17 of 35