Brüel & Kjaer Vibro ds822 Serie Manuel page 40

4 mm displacement sensor system series ds822 ATEX
EN
User manual
1 Safety
N
OTE
This manual is a part of the product. Read the manual carefully before using the
product and keep it accessible for future use.
C
AUTION
This symbol warns of dangerous situations which can result from misuse of the
product.
N
OTE
This symbol provides general and useful information for using the product.
1.1 Disclaimer
Observing this technical documentation is a basic requirement for the proper and safe opera-
tion of the product. We accept no liability for personal injury, damage to property or financial
loss caused by failure to observe this technical documentation. In such cases, any liability for
material defects is excluded.
1.2 Intended usage
The eddy-current displacement sensor system is intended solely for measuring mechanical
distances and oscillations and is used primarily for the condition monitoring of slide bearings or
rotating shafts. The use of the measuring chain is indoors or outdoors, when the driver is instal-
led in a suitable protective housing.
If sensors and cables are used in a way not described in the relevant user manuals, function
and protection may be impaired and serious personal damage, death or serious, irreversible
injuries may result.
Exclusively use sensor as specified in data sheet. Any use other than specified is consid-
•
ered inappropriate. Brüel & Kjær Vibro does not assume any liability for damages resulting
from inappropriate use. The user is solely responsible.
Mounted sensors must not be used as steps.
•
Ensure that system is exposed only to admissible environmental influences specified in
•
technical system data sheet.
Maintain electrical equipment in regular intervals. Remedy defects, e.g. loose wires, defec-
•
tive connectors, immediately.
Page 4 of 35
!
!
| Safety
© Brüel & Kjær Vibro C105070.001 / V04

Technical alterations reserved!