Brüel & Kjaer Vibro ds822 Serie Manuel page 46

4 mm displacement sensor system series ds822 ATEX
EN
Instructions
3 Delivery, storage, transport
Observe the safety information in chapter "Safety"!
3.1 Delivery
Check the packaging for damage upon delivery and make sure that the contents are complete.
Components included in scope of
Supplied components
Displacement sensor
Protection cap
a
2 nuts
1 sealing ring
Extension cable
Driver
Assembly adapter
Acceptance test certifi-
cate acc. to DIN EN
10204
Measurement protocol
(works calibration)
User Manual
a. not available for ds3003 (sensor for rear-side mounting)
b. only available for ds3003, sensor for rear-side mounting, operating temperature range for o-ring -40 °C to +180 °C,
for lower temperatures down to -55 °C o-ring (silicone) on request.
c. not available if the length of the displacement sensor with integrated cable corresponds to the nominal system length
of 5 m or 10 m.
Page 10 of 35
supply:
Displacement
sensor
X
X
X
b
X
c
X
X
| Delivery, storage, transport
Extension
Driver
cable
X
X
X
© Brüel & Kjær Vibro
Complete
displacemen
t sensor
system
X
X
X
X
X
X X
X X
X X
X
X X
C105070.001 / V04

Technical alterations reserved!