Publicité
Les langues disponibles
Les langues disponibles
CHARGING THE CLIPPER
1 .
Slide the power switch to OFF position.
2.
Connect the plug from the AC adapter to the unit. Plug adapter
into wall outlet. The LED will turn red to indicate charging.
3.
Place the unit on the stand or on a counter.
• It will take approximately 3 hours for the clipper to fully charge, as
indicated by the blue LED light. This will give you approximately 3
hours or more of run time.
• Your clipper can be quick charged for approximately 1 hour,
providing about 75 minutes of run time. Note the LED light may
not change from red to blue.
• Important Note: To prolong the life of your battery, it is recom‑
mend that you wait for the flashing red LED before charging
your clipper.
ABOUT THE LED DISPLAY
.
Your clipper has one LED to indicate the different modes.
Red: the unit is charging.
Blue: the unit is fully charged.
Slow Flashing Red: early warning indicates the unit will soon
need to be charged.
Rapid Flashing Red: indicates only 10 to 15 minutes more
run time.
7
Publicité
