PRO-POINT 8474488 Manuel D'utilisateur page 18

V 3.03
Twin Tank Wheelbarrow Portable Air Compressor
MAINTENANCE HINTS
1. Use a soap/water solution to check for air leaks.
2. Never clean filters with a flammable solvent.
3. Re-torque head bolts only after the pump has cooled.
4. Never weld on air tanks.
5. Use heat to loosen liquid sealant on drain valves, engine
pulleys and flywheels before attempting to remove.
LUBRICATION
NOTICE! Replace the oil after the first 40 hours of operation. Do
not use a detergent oil.
Inspect and lubricate the device when required.
The compressor is shipped with 30 WT oil in the pump and 10w
30 oil in the motor. Change the oil if necessary based on the
temperature range found in the Oil Type Table.
Prior to daily operation, make a habit of checking the oil level
in your compressor pump. A sight gauge on the outside of the
pump's crankcase is provided to make the job easier. ALWAYS
maintain the oil level to read 2/3 full on the sight gauge. Oil
levels over this amount will result in oil blowing past the rings or
through the crankcase breather. Lower amounts of oil will result in
insufficient lubrication of moving parts.
Do not operate the pump with an inadequate or excessive amount
of oil. This model is splash lubricated by means of dippers on the
connecting rods. The pump MUST be operated in a level position
for proper lubrication.
18 For technical questions call 1-800-665-8685
8474488