Use; Cleaning And Storage - MAXXMEE CBL-SV1606 Mode D'emploi

EN
2. Connect the mains adapter to a plug
socket.
The charge control lamps (13) start to
flash and the battery (15) is charging.
If all charge control lamps are con-
stantly lit, the battery is fully charged.

USE

Please Note!
■
Make sure that there are no large,
sharp objects on the surface which is
to be cleaned.
■
Note the MAX marking of the dust
container. If the marking is reached
during use, empty the dust container.
Empty and clean the dust container
after every use. The filters must also
be regularly cleaned in order to pre-
vent overloading of the motor.
■
Switch off the device after you finish
cleaning each surface to significantly
increase the operating time on each
battery charge. Charge up the battery
after use (see the "Charging Up the
Battery" chapter).
L
The device cannot be operated
when it is connected to the mains
power. Disconnect the connecting
cable (2) prior to use.
1. Select a nozzle (see the "Nozzles and
Extension Tube" chapter) and plug
it into the suction opening (21). You
must hear it engage. For a longer
reach, plug the extension tube (5) in
between.
• To pull a nozzle or the extension tube
out again, press the respective release
button.
2. Switch on the device and guide the
nozzle over the area to be cleaned. To
switch on at suction level I, press the
On / Off button (11) once. If the
18
02026_Inlay_de-en-fr-nl_A5_V1.indb 18 02026_Inlay_de-en-fr-nl_A5_V1.indb 18
On / Off button is pressed again,
the suction power increases to level 2.
3. To switch off the device, press the
On / Off button a third time.
4. To ensure optimum performance of
the device, empty and if necessary
clean the dust container after every
use (see next chapter).

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents to clean the device.
They may damage the surfaces.
L
The filters may lose some of their
colour over time. This is normal
and does not have any adverse
effect on function.
Emptying the Dust Container
Take off the extension tube (5) if it is
located on the device.
1. Hold the dust container (20) over an
open dustbin and press the button for
opening the dust container flap (19).
The dust container flap (16) opens
and the dirt drops out.
2. To close it, press the dust container
flap onto the dust container. You must
hear it engage.
Cleaning the Dust Container, Metal
Filter and EPA8 Filter
1. Open the dust container, reach in and
twist the bottom of the metal fil-
ter (17) a little until it is detached from
the device.
2. Take the metal filter out of the dust
container.
3. The EPA8 filter (18) is inserted in the
metal filter. Twist it a little and pull it
out.
14.10.2020 14:39:56 14.10.2020 14:39:56