Tips And Notes; Use; Cleaning And Storage - MAXXMEE MC619P Mode D'emploi

EN

TIPS AND NOTES

• Always clean mattresses on both
sides.
• We recommend cleaning new mat-
tresses once a month. Older mattres-
ses should initially be cleaned every
day for a week. We then recommend
cleaning them once a month.
• The fi lter should be replaced every
12 – 18 months; the UV-C lamp (12)
should be replaced every 12 – 24
months. If you have any questions
about spare parts, please contact the
customer service department via our
website:
www.dspro.de/kundenservice

USE

Please Note!
■
The device should only be used if it
has been fully and correctly assem-
bled! The dust container and the
fi lter must be inserted and must
not be damaged! If the dirt were to
get inside the motor unit, this could
damage the motor.
■ Make sure that the safety switches of
the UV-C lamp are not blocked!
1. Insert the mains plug into a properly
installed plug socket that is easily
accessible.
2. Place the device down fl at on the
surface which is to be cleaned.
3. Press the On / Off switch (1) to switch
on the device. The device starts to
vacuum and the UV-C lamp (12) and
the vibration head (9) switches on.
 
The vibration shakes up the
surface which is to be cleaned
and the dust which is agitated
is sucked in through the suction
opening (10).
12
4. Guide the device very slowly and
evenly over the surface to be clea-
ned.
5. After vacuuming, press the On / Off
switch to switch off the device.
6. Remove the mains plug from the plug
socket.

CLEANING AND STORAGE

Please Note!
■
Empty the dust container each time
after you use the device. The fi lter
must also be regularly cleaned in
order to prevent overloading of the
motor.
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage
the surfaces.
■ CAUTION – Danger of Burns! The
UV-C lamp will become hot during
use. Allow the UV-C lamp to cool
suffi ciently after using the device.
• Make sure that the mains plug has
been pulled out and the device is
disconnected from the power.
• As required, wipe down the motor
unit with a damp soft cloth. Then dry
it with a soft cloth.
• Wipe out the recess for the dust con-
tainer (4) with a duster.
Cleaning the Dust Container and
HEPA Filter
1. Reach into the recess in the dust
container (4) and pull it up and out of
the motor unit (3).
2. Pull the HEPA-fi lter out of the dust
container.
3. Empty the dust container.
4. Wipe out the dust container with a
dry duster if necessary.