Stanley MasterFix XGrip N08QI Mode D'emploi page 5

3. Safety
3.1 Safety instructions
Read the manual
Use safety goggles. This also applies to persons in the immediate surroundings.
Use hearing protection when the sound level exceeds 85 dB(A).
Use safety gloves.
• Keep your fi ngers away from the front when connecting the compressed air.
• Never direct the tool at persons.
3.2 Work environment
- Set a constant air pressure to 5 - 7 bars (maximum 7 bars).
•
• Keep the work environment clean and neat.
• Use dry, fi ltered and with anti-corrosive oillubricated air.
• If not available, put 0.1 ml (approximately 5 drops) of anti- corrosive lubricating oil in air connection of tool
three times each operating day.
• Work in a frost-free environment.
• The connection to the tools is G¼". A connection nipple has not been included. Provide an appropriate
solution yourself.
3.3 Tools
Never use the tools
- when the anvil (A) is missing;
• Check the tools for damage before connecting the air pressure.
• Keep the tools in an optimum condition.
• Switch off the air supply when the tools are not used.
• Make sure that the fl exible connection hose (M) is not pressurised when disconnecting.
• Do not modify the tools in any way.
• Only use the device for appropriate purposes
4. Operation
4.1 Fitting the correct mandrel/adapter (see Fig. 2)
4.2 Placing the rivet nut/bolt (see Fig. 3)
4.3 Setting the pressure (see Fig. 1)
• The pressure can be adjusted by the set screw (J) at the bottom of the tool. The tool is set at its minimum
pressure when it leaves the factory.
• Turn the set screw(J) clockwise to increase the pressure. Turn the set screw (J) anti-clockwise to reduce the
pressure. When reducing the pressure, always operate the trigger (G) to let the pressure release.
• The set pressure can be read from the pressure indication (L).
When adjusting the pressure belonging to the nut/bolt:
• fi rst adjust to the minimum pressure and then slowly increase;
• place a nut/bolt on the mandrel/adapter (A)
• operate the trigger(G) and increase the pressure by turning the set screw(J) clockwise until the nut/bolt
deforms.
If problems should occur with the setting of the pressure, disconnect the tool from the compressed air supply, to
release the tool from the pressure.
XGrip N08QI - XGrip N10QI
3