KTM 76908915044 Mode D'emploi page 23

Info
The lower part of the license plate holder is no longer
used.
–
Remove nuts
–
Slip out right turn signal
501454-01
–
Slip out the license plate lamp cable on license plate hol-
1
der (included).
–
Mount rubber grommet
again.
501455-01
–
Position right turn signal
–
bo
Mount nuts
501456-01
–
Position the license plate holder and mount and tighten
8
screws .
Guideline
Screw, license plate
holder
501457-01
–
Join left turn signal plug-in connector
–
Join right turn signal plug-in connector
–
Join tail light plug-in connector
–
Join license plate lamp plug-in connector
–
Position the cable without tension and secure it with a cable
tie.
501458-01
bo
with toothed washers and washers.
bp
and left turn signal
2
(included) and thread in the cable
bp
and left turn signal
with toothed washers and washers and tighten.
M6x15 8 Nm (5.9 lbf ft)
9
.
bk
bl
.
bn
ASSEMBLY 5
bq
.
bq
.
.
.
9