Clarke FOCUS II Micro Rider Instructions D'utilisation page 17

Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo loor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
Pad installation/removal (for FOCUS II MICRO RIDER 28 BOOST
The machine with BOOST
1. Insert the ignition key (58) and turn it to "I".
WARNING!
Before turning on the switch (63), always check that between the deck (28) and the machine there is no foreign
material which may prevent the deck from lifting.
2. Lift the deck by pressing the switch (63).
3. Turn the ignition key (58) to "0" and remove it.
4. Install the pad (A, Fig. 3) so that it engages the plates on the BOOST
5. To remove the pad perform steps 1 to 3, then manually release the pad from the deck plate.
Squeegee installation
6. Install the squeegee (30) and fasten it with the handwheels (34), then connect the vacuum hose (31) to the squeegee.
With the handwheel (35), adjust the squeegee so that the rear blades (18) - in all its length - touches the loor and the front
7.
blade is slightly detached from the loor.
7/11
HEAVY GRIT LITE GRIT
deck can be equipped with pads according to the type of loor to be cleaned.
®
INSTRUCTIONS FOR USE
MEDIUM GRIT POLY
®
)
® deck.
Figure 3
9099236000 - FOCUS II Micro Rider
ENGLISH
UNIVERSAL
SOFT NYLON
BRUSH 5K
P100437
15