Key Automation 900CT-201 Manuel D'emploi page 16

After a breakaway of 1.5 seconds, the electronic force control activates which distributes the power
supply, adjusting the value by means of parameter L.
N.B. for maximum thrust loads refer to current standards.
The CT-201 unit is compatible with the following Key Automation receivers of the MEMO snap-in
series: 900RXI-22 / 900RXI-42 / 900RXI-42R
• The installation of the automation must be performed properly by qualified personnel in pos-
session of legal requirements and in compliance with machine directive 98/37/CE and standards
EN13241-1, EN 12453 and EN 12445.
• Check the solidity of existing structures (columns, hinges, doors) in relation to the force generated
by the motor.
• Check that there are suitably sturdy mechanical stops at the end of opening and closing travel of
the doors.
• Analyze the risks of the automation and adopt necessary safety measures and warnings.
• Install controls (such as the key selector) so that the user is not in a hazardous position.
• Upon completion of installation, check the safety devices several times, as well as those for si-
gnalling and automation release.
• Provide the automation with the EC label or tag that contains the danger information and identifi-
cation data.
• Give the final user the instructions for use, safety warnings and the EC declaration of conformity.
• Make sure the user understands proper automatic, manual and emergency operation of the auto-
mation.
• Inform the user in writing (for example in the instructions for use) of any unprotected residual risks
and foreseeable improper use.
• Provide a maintenance schedule for the system (at least every 6 months for the safeties) with an
appropriate register of work performed.
• Keep this instruction manual for future reference.
• Key Automation S.p.A. reserves the right to make, at any time, any modifications which may be
required to improve appearance and/or operation.
This product is composed of various components which may in turn contain pollutants.
Do not dispose of it in the environment! Find out about the method for recycling or di-
sposing of the product in compliance with current local laws.
ADJUSTMENT OF MOTOR FORCE
RADIO CONNECTOR
FINAL WARNINGS
DISPOSAL
16