WOLFF 73888 Mode D'emploi Original page 22

► Semi-fl exible tiles:
Provided they are not extremely fl exible, semi-fl exible
tiles can be removed without pre-cutting them.
► Parquet:
Prior to performing the stripping work in bladewidths,
saw the parquet parallel to the installation
direction. Depending on the glue, it may need to be
sawed several times.
► Ceramic tiles:
In general, it must be determined at the construction
site whether and with which tools the tiles can be
eff ectively removed.
Important blade recommendation:
In general, no statements can be made on which
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
►
With U-blades, the pre-cutting step in not necessary
for many fl exible coverings, the coverings must be
checked on-site.If the tyre wear is highly visible on
the surface, the U-blade should not be used.
► We recommend using fl at blades of varying lengths
and widths for fl exible, elastic fl oor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
this case, the blade must be inserted with the blade
edge down.
► The heavy-duty special blades are generally suitable
for hard coverings, such as parquet.
6.0 Maintenance and Service
Maintenance and Cleaning
►
Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service centre
for WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specifi ed
on the type plate of the machine.
6.1 Lubrication of the Impact fig. G.a
The ROBO-STRIPPER is largely maintenance-free. The slide
bearing of the oscillator mounting must be relubricated daily
or at the latest every 10 hours. The grease nipples (12) are
on the right and left side at the front. The grease escaping
during operation causes dirt particles to be washed out.
Apply the supplied grease gun to the grease nipples and
actuate approx. 3 times until some grease has escaped
from the sleeves at the front. Only the original grease
(Art. No. 087733) "Lagermeister WHS 2002".
6.2 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff -tools.com can be found.
7.0 Troubleshooting
Fault Possible cause
The machine Power supply
does not start interrupted
Defective cable
Defective plug
Higher exer- Cutting blade dull
tion of force
required while
workingt
8.0 Disposal information
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its implemen-
tation into national right, power tools that are
no longer usable must be collected separately and dispo-
sed of in an environmentally correct manner.
Subject to change without notice.
EN
Remedy
Contact
Electrician
For repair and
/or replace parts
Replace
cutting blade
or resharpen
22