Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools needed
•
Drill
•
1¼" (3 cm) drill bit
•
³⁄₁₆" (0.5 cm) drill bit
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Pliers
•
Caulking gun and weatherproof caulking compound
•
Vent clamps
•
Jigsaw or keyhole saw
•
Flat-blade screwdriver
•
Metal snips
•
Phillips screwdriver
Parts needed
•
6 - 9 AWG wires, one each of the following colors: black,
white, red, blue, gray, and green or green/yellow (ground)
NOTE: The length of the conduit and AWG wires is
determined by the distance between the external blower
motor and range hood terminal boxes.
•
11 - UL listed wire connectors
Parts supplied
Remove parts from packages. Check that all parts are
included.
Strain relief connector
4.2x8 mm screws
6-wire blower connector
6.4x18 mm flat washers
Rectangular bracket - Motor cover
Bracket- Connector support
4
6.3x60 mm screws (Wood/Concrete)
9-wire blower connector
Ø 12 mm
Strap 2.5x95 mm
Neoprene washers
10x50 mm wall anchors (plywood)
2
10x60 mm wall anchors (concrete)
TOP BORDER
BORD SUPERIEUR
BORDE SUPERIOR
6
1
Installation template
4
2
1
Strain Reliefs
Ø 15.9 mm
6x13.5 mm
Torx 20 adapter
Torx 10 adapter
Ø 10
/
"
Ø
/
"
1
13
4
16
(Ø 260 mm)
(Ø 21 mm)
WIRING HOLE
TROU DE CÂBLAGE
ORIFICIO DE CABLEADO
Ø 8
1
/
"
4
A
(Ø 210 mm)
7
1
1
2
1
1
3
20
7
7
1
Publicité
Chapitres
Table des Matières
