Enerwatt EWV-FAT-FLEX-BK Manuel De L'utilisateur page 17

4. OPERATION AND ADJUSTMENT
4.1 PAS system
The pedal assist system is also known as the 1:1 PAS system. When you do not rotate the throttle but ride only with pedal power, the
system's sensor will automatically sense your riding speed and control the motor to assist you automatically in a driving force with
the same speed, so as to make your ride easier over longer distances.
4.2 Operating the display
There are 5 power-aid levels, the maximum speed is 35 Km/h.
The LCD meter adopts the structural form with part design between the main part and operating buttons.
There are three keys on the operating panel of the button box, the (alt text UP)
(alt text DOWN) button.
Hold down the button (SW), the meter turns on and normal operation begins, and it provides the controller with power supply.
Under normal operating status, press the
power supply of controllers. When the bike has stopped and no buttons have been pressed for five minutes, the meter will automatically
shut down, and the power supply of the electric bike will be powered off. In power off mode, the power consumption of the meter
and controller is zero.
Battery Capacity
Indicator
Power Assist Ratio
Gear and Cruise Function
4.3 Charging battery
As there is a delay between the manufacturing stage and the first usage of a new electrical bicycle (manufacturing, storage, delivery),
it is vital to charge the battery before first use. It is possible that the battery is not fully charged. Using an alternate charger may damage
the battery, and could even lead to a fire or other dangerous result. Damage to the battery resulting from use of a charger other than
that provided is not covered under our warranty.
4.3.1 Installation and charging of battery
1. Carefully check whether the rated input voltage of the charger is consistent with the supply voltage.
2. The battery can be put directly on the bike for charging and can also be removed from the bike to be charged.
3. Connect the charger's output plug to the battery's charging port and then connect the charger's
input plug to the AC power supply.
4. If the battery and charger power indicators are on, this means the battery is charging.
5. After charging, first pull out the input plug of the charger, then the output plug.
The battery needs 6 to 8 hours to charge. When the indicator turns from red to green, the battery is fully charged.
A new bike may need to be charged for 8 to 9 hours after fully discharging for the first time.
This is to activate the active substances inside the battery. Later, it can be recharged before the battery is completely depleted.
button (SW) for a couple of seconds and the meter will turn off, shutting down the
Backlights and Brake
Headlights Status Status
Trip Distance or Real-time
Battery Voltage
button, the
Vehicle Speed Running
Display counter
Environment Temperature
MODEL: EWV-FAT-FLEX-BK
(alt text SW) button and the
6 Km/H Power Assist
Push Function
Motor Operation Power or
Motor Running temperature
USER'S MANUAL
15