Publicité
Les langues disponibles
Les langues disponibles
Always secure child in booster, even
on short trips, as this is when most
accidents occur. DO NOT leave this
booster, or other items unbelted or
unsecured in your vehicle. Remove
the booster seat from the car if not
regular used and store in a dry, sun-
protected surrounding.
It's recommended not to use a
second-hand booster seat whose
history is not known. It may have
invisible structural damages or
defects due to incorrect usage/
storage.
DO NOT use any load bearing
contact points other than those
described in the instructions and
marked on the booster.
DO NOT install this booster under the
following conditions:
1. Vehicle seats facing sideways
or rearward with respect to the
vehicle's direction of travel.
2. Vehicle seats movable during
installation.
Consult the retailer for issues
concerning maintenance repair and
part replacement.
To avoid burns, never put hot liquids
in your booster's cupholders.
Product
Information
1. This is an Enhanced Child Restraint
System, intended to use as a
Non-integral Universal Enhanced
Child Restraint System from
135cm-150cm.
2. It is approved to the latest UN
Regulation R129/03.
Product
Booster seat
Materials
Plastics, Metal, Fabrics
Patent No.
Patents pending
Suitable for Child height 135cm-
150cm (Reference age
7-12 years).
Installation Forward facing (in
vehicle travel direction)
Concerns on
Installation
1
3
See images
-
Installation with
3-point-belt
4
10
See images
-
Insert the end of shoulder belt
positioning clip webbing into the
6
hole on the base.
7
! Please check the direction of
10
shoulder harness anchor as
to avoid hurting the child's back
if shoulder harness anchor is in
the opposite direction.
! Pull the shoulder belt positioning
clip webbing slightly to make
sure the webbing fixed on the
base.
Make the webbing and clip wind
round bar, then tension webbing.
7
8
! Slide shoulder harness anchor to
adjust webbing length.
Slide the shoulder belt positioning
clip to make sure the clip is close to
9
-1 buckle the
child's shoulder,
9
vehicle safety belt.
-3
! To achieve the safest installation,
we suggest the shoulder belt
positioning clip should be level
with the highest point of the
child's shoulder.
DO NOT position vehicle belt over
top of the armrests. It must pass
9
-2
underneath the armrests.
The booster can not be used if the
vehicle safety belt buckle (female
buckle end) is too long to anchor the
9
booster securely.
-4
! After your child is placed in this
booster, the safety belt must
be used correctly, and ensure
that any lap strap is worn low
down, so that the pelvis is firmly
9
engaged.
! Place a booster firmly against the
back of a forward-facing vehicle
seat equipped with a lap/
shoulder belt.
! Any straps holding the booster
to the vehicle should be tight ,
any straps restraining the child
should be adjusted to the child's
body, and the straps should not
be twisted.
Rear view of child sitting in seat.
! The shoulder belt positioning
clip must through the vertical
bar of the base farthest from
where the vehicle shoulder belt
lays across the child.
! Please store shoulder belt
positioning clip on the bottom
of base when don't use it.
Use Cupholders
11
See image
Detach Soft Goods
12
See image
8
10
Publicité
