Efco Oleo-Mac APACHE 92 Manuel D'utilisation Et D'entretien page 42

Install the sharpened blade proceeding in the reverse sequence.
} Use new, unused M16 lock nuts.
} Before replacing the second blade turn the blade holder with your hand by 180°.
6.3.7 MOWING DECK - CHECKING THE DRIVE PULLEY OF THE DECK
The mowing deck drive belt pulley and belt are protected under a plastic cover. For the
purpose of cleaning, inspection and adjustment, this cover can be removed by unscrewing
6.3.7 the two screws on its sides.
Before every use of the machine, check the
fastening bolt of the pulley. The bolt should
be pulled tight with a torque of 80 Nm.
The pulley is accessible after lowering the
mowing deck to the lowest position.
6.3.8 CHECKING AND ADJUSTING THE DRIVE BELT
When working on various parts of the machine's drive always turn off the engine and take
the key out of the ignition.
Regularly check the wear and tension of V-belts and
the tensioning mechanism.
The drive V-belts (travel and mowing) are automatically
tensioned by a spring and a pulley. Before starting
work or at least after every 50 hours of operation check
the wear on the V-belts and the working order of the
tensioning mechanism.
Adjust the position of the drive belt tensioning pulley
using adjusting nuts.
Distance A = 60±2 mm.
Distance B = 78 mm (set the mowing deck elevation
adjustment lever to the second last position)
When attaching a new belt pay special attention when working with the machine because the
belt is not yet sufficiently run-in.
6.3.9 REPLACING BELTS
Replacing drive belts is a relatively demanding operation, which needs to performed by an authorised
service centre.
6.3.10 ADJUSTING THE CRUISE CONTROL LEVER
If cruise control is activated and the drive lever is independently returning to position "N", then it is
necessary to adjust the cruise control lever. Have this task performed at a specialised service centre.
42
80 Nm
A A