Disposal Of The Packaging - Efco Oleo-Mac APACHE 92 Manuel D'utilisation Et D'entretien

3. PREPARING FOR THE MACHINE FOR OPERATION
3.1 UNPACKING AND INSPECTING THE CONTENTS
The riding mower is supplied wrapped and in crate packaging. For transportation reasons some machine
assemblies are disassembled in the production plant and it is necessary to install them before putting the
machine into operation. The unpacking and preparation for operation is performed by the seller within
the scope of the pre-sale service.
Inspect immediately after delivery that the packed machine has not been damaged. In the
event of damage inform the carrier. If the complaint is not lodged in time, no potential
demands can be claimed.
Check that the machine model is the same as you ordered. In the event of an irregularity do
not unpack the machine and immediately report this discrepancy to the supplier.
1. Crate packaging
2. Seat
3. Folding frame
3.1 4. Steering wheel
5. Documentation (located underneath the hood)
Using a suitable tool (e.g. crowbar or hammer, etc.) remove the crate (1) and the packaging on the
machine.
Visually inspect the machine and assemblies for damage that may have occurred during transport.
Unpack all separatelz packed assemblies and inspect them.
The basic package includes:
} Riding mower
} Seat (2)
} Folding frame in the folded state (3)
} Steering wheel (4)
} Documentation (5) (packed parts list, user's manual for the riding mower, user's manual for the engine,
user's manual for the battery, service log book)

3.2 DISPOSAL OF THE PACKAGING

After unpacking the machine ensure that the packaging material is properly disposed
of or recycled. The disposal must conform to relevant waste disposal laws valid in
the user's country.
Disposal may be performed by a specialised company.
3.3 ASSEMBLY OF THE SEPARATELY PACKED ASSEMBLIES
Due to the technical nature of this task the machine is prepared for operation by the seller of
your riding mower (according to the following instructions).
Before starting installation, remove all covering, protective and fastening materials.
a) Install the seat springs:
} Tilt out the seat.
} U nscrew the bolts holding down the seating spring under the bracket. Then install the
springs so that they are above the bracket.
} Set the appropriate distance of the seat from the steering wheel by pressing the seat
positioning lever which is a part of the seat.
21
3.3a