Starting The Engine - RedMax GZ4000 Mode D'emploi

F7
F8
F9
F10
F11
28
English
8. Operation
WARNING
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.

■ STARTING THE ENGINE

1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F7)
2. Set the switch to "I" position. (F8)
(1) Chain oil
(2) Fuel
(3) Switch
(4) Throttle lever
(5) Throttle interlock
3. Pull out the choke knob to the second-stage
position. The choke will close and the throttle lever
will then be set in the starting position [F10-(a)].
(6) Choke knob
NOTE
When restarting immediately after stopping the engine,
set the Choke knob in the first-stage position (choke
open and throttle lever in the starting position).
NOTE
Once the choke knob has been pulled out, it will not
return to the operating position even if you press down
on it with your finger. When you wish to return the
choke knob to the operating position, pull out the
throttle lever instead.
4. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F11)
WARNING
Do not start the engine while the chain saw hangs
in one hand. The saw chain may touch your body.
This in very dangerous.