GYS SMARTFEED M-4 Mode D'emploi page 12

POWER SUPPLY - POWER UP
The SMARTFEED M-4 robotic wire feeder has been designed to work exclusively with the NEOPULSE range:
- NEOPULSE 500 G (ref. 014503)
- NEOPULSE 400 G (ref. 014497)
- NEOPULSE 320 C (ref. 062474)
This reel can be used with manual and robotic MIG-MAG torches. The connection between these two elements is made through a dedicated beam.
PRECAUTIONS
Make sure the welding generator is switched off when connecting or disconnecting the wire feeder.
WIRE LOADING
a
b
- Check the marking on the roller to ensure that the rollers are suitable for the diameter of the wire
and the material of the wire (for a Ø 1.2 wire, use the Ø 1.2 groove).
- Use rollers with V-groove for steel and other hard wires.
- Use rollers with U-slots for aluminium and other soft alloy wires.
COLLISION AND WIRE-END SENSOR CONNECTORS
The SMARTFEED M-4 is equipped with a collision-sensor connector on the front side of the machine (I-4) as well as an
end-of-wire sensor connector on the device's rear side (I-7). These two connectors are identical (M8 female/three-pin)
and have the same wiring.
Voltage: 24 VDC
Max. current: 250 mA
12
+ HMI remote option possible
a
To change the rollers, proceed as follows:
- Loosen the rollers (a) to the maximum and lower them.
- Unlock the rollers by turning the retaining rings (b) a quarter turn.
- Fit the appropriate drive rollers for your application and lock the retaining bands.
The rollers supplied are double steel groove rollers (1.0 and 1.2).
: visible inscription on the roller (example: 1.2 VT)
: groove to be used
To install the welding wire, proceed as follows:
- Loosen the knobs as much as possible and lower them.
- Insert the wire, then close the motorised reel and tighten the knobs according to the instructions.
- Operate the motor by pressing the manual wire feed button (I-9).
SMARTFEED M-4
(ref. 062122)
EN
4 (N/O)
3 (-)
1 (+)