Publicité
Les langues disponibles
Les langues disponibles
5 Troubleshooting
Warning! Disconnect the air hose before you do any maintenance
on the product.
Problem
Air leaks near the top of the product or at the
trigger.
The product does not operate correctly.
Air leaks at the bottom of the product.
Nails get stuck in the product.
Other.
6 Disposal
6.1 To discard the product
● Make sure that you follow local regulations when you discard the
product. Do not burn the product.
7 Technical data
Min. air pressure
Max. air pressure
Air intake
Nail width
Nail length
Nail capacity, 210 collation angle
Sound power level, LwA
Sound pressure level, LpA
Vibration level
1
Weight
Air consumption rate
Warning! The actual vibration level when using power tools may
differ from the specified maximum value, depending on how the tool is
used. It is therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of exposure in
actual operating conditions (taking into account all stages of the work
cycle, e.g. the time when the tool is switched off and when it is idling, in
addition to the start-up time).
1 The declared vibration value, which has been measured by a stand-
ardized test method, can be used to compare different tools with each
other and for a preliminary assessment of exposure.
15
Screws are not tightened.
O-rings or seal are worn or damaged.
Low air pressure.
Not enough lubricant in the product.
O-rings or seal are worn or damaged.
Screws are not tightened.
O-rings or seal are worn or damaged.
Incorrect nails are loaded in the magazine.
Damaged nails.
Screws for magazine or depth adjuster are not
tightened.
Magazine is dirty.
Drive mechanism is worn or damaged.
Technical data
4.9 kg/cm
2
8.4 kg/cm
2
1/4"
ø 2.87–3.33 mm
55–90 mm
60
98 dB(A) K = 3 dB
85 dB(A) K = 3 dB
8.1 m/s
K = 1.5 m/s
2
2
3.6 kg
156 l/min at 6.2 bar
Cause
Tighten the screws.
Replace damaged or worn parts.
Do a check of the air pressure.
Put 5–6 drops of pneumatic oil in the air inlet.
Replace damaged or worn parts.
Tighten the screws.
Replace damaged or worn parts.
Use approved nails of the correct size.
Replace with undamaged nails.
Tighten the screws.
Clean the magazine.
Replace damaged or worn parts.
Speak to an authorized service center.
Action
2022_001
Publicité
