Taurus V302MT Mode D'emploi page 18

The voltage corresponds to the value stated on the label on the bottom of the appliance.
The cable cross section is capable of withstanding the load specified on the hob's label. Do not use adapters,
reducers or bypass devices to connect the appliance to the power supply, as these may lead to overheating and
fire.
The power cable must not be in contact with any hot part and be positioned in such a way that at no point does
its temperature exceed 75ºC.
Ask the electrician whether the home wiring system is adequate or needs to be modified. Any modifications
must be made by a qualified electrician.
Brown = L or Live
Blue = N or Neutral
Green and Yellow=E or Earth
AFTER INSTALLING:
Check that the cable for the hob is not accessible through any doors or cabinets.
Check that there is adequate circulation of fresh air from the outside to the base of the worktop
If the hob is installed on top of a cabinet or drawer, install thermal protection under the base of the hob.
The isolation switch must be readily accessible to the user.
INSTRUCTIONS
USE
Place the appropriate cookware on the cooking area that you want to use.
Make sure that the bottom of the cookware and surface are dry and clean.
Turn the appliance on using the on/off switch.
For the V302MT hob, press the + button for the area you want to use (Left top area, Right bottom
area)
For the other models: Switch the device on by pressing the On/Off button and wait until "0"
appears on the displays
Depending on the area where the cookware is placed, press the appropriate cooking area
selection control. The selected 0 symbol will flash. Move your finger across the sliding control
towards + or – to select the desired power. The power control goes from 0 to 9, increasing the
power in numerical order. If no power setting is selected, the hob will switch off automatically after
60 seconds. The power setting can be changed any time during cooking.
In order to minimize the generation of acrylamide during the cooking process, do not overbrown or
burn the food.
Notes: When a control is pressed, the hob emits an audible signal.
If the power supply is interrupted during cooking, all selections made are cancelled.
USE OF THE TOUCH CONTROLS
The controls respond to touch, so there is no need to apply any pressure.
Use the flat of the finger, not the tip.
A beep is emitted each time a touch control is used.