Taurus V302MT Mode D'emploi page 16

-Cut the worktop as per the sizes shown in the diagram.
-For assembly and use, leave a space of at least 5 cm around the hole.
-Make sure the worktop is at least 30mm thick. To prevent the heat given off by the hob from
deforming the worktop, the worktop must be made of a heat-resistant material.
Model L(mm)
V302MT 290
V6031S 590
V6041S 590
Check that the hob is properly ventilated, that the air inlet and outlet are not blocked and that it
operates correctly.
Note: There must be at least a 650 mm safety distance between the hob and any cabinet located
above the hob.
A(mm)
650
W(mm) H(mm)
520 47
520 52
520 52
B(mm) C(mm)
20 min
50 min
D(mm) A(mm)
43 265
43 560
43 560
E
D
Air Inlet
B(mm) X(mm)
500 50 min
490 50 min
490 50 min
E
5mm Air Outlet