Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OptiHeat Control (3 step
Residual heat indicator)
WARNING!
is a risk of burns from residual
heat.

DAILY USE

WARNING! Refer to Safety
chapters.
Activating and deactivating
Touch
for 1 second to activate or
deactivate the hob.
Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• you do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the hob
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
/
/
There
The hob deacti‐
vates after
6 hours
5 hours
4 hours
1.5 hour
The indicators show the level of the
residual heat for the cooking zones you
are currently using. The indicators may
also come on for the neighbouring cooking
zones even if you are not using them.
The heat setting
Touch
to increase the heat setting.
Touch
to decrease the heat setting.
Touch
and
at the same time to
deactivate the cooking zone.
Activating and deactivating the
outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
Timer
• Count Down Timer
You can use this function to set the length
of a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function or change the
time: touch
or
time (00 - 99 minutes). When the indicator
of the cooking zone starts to flash, the
time counts down.
To see the remaining time: touch
set the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
of the timer to set the
to
27

Publicité

Table des Matières
loading

Table des Matières