Winding The Bobbin; Threading Bobbin Case - Janome 2206 Livre D'instructions

1
Janome 2206 Instruction Manual
2
4 5
7
1
2
3
www.toews.com
3
6
16

Winding the Bobbin

z
Pull the handwheel out.
x Draw thread from the spool.
Guide the thread around the bobbin winder thread guide.
Insert the thread through the hole in the bobbin from
c
the inside to the outside.
Put the bobbin on the bobbin winder spindle.
v
Push it to the right.
b
With the free end of the thread held in your hand,
depress the foot control.
Stop the machine when it has made a few turns, and
cut the thread close to the hole in the bobbin.
n
Depress the foot control again.
When the bobbin is fully wound, stop the machine.
Return the bobbin winder spindle to its original position
by moving the spindle to the left, and cut the thread.
m
Push the handwheel back to its original position.
Note:
Return the bobbin winder spindle when the machine stops.

Threading Bobbin Case

z
Place the bobbin into the bobbin case.
Make sure the thread unwinds in the direction of arrow.
x
Pull the thread into the bobbin case slot.
c
Draw the thread under the tension spring and into the
delivery eye.
* Leave about 10 cm (4") of free thread.
2206 Owners Manual/ User Guide