The 1 Way Companion Remote Control; Selecting Transmission Channel; Battery Replacement - AstroStart RSS-5224 Manuel De L'usager

THE 1 WAY COMPANION REMOTE CONTROL

Your remote control can transmit on two different channels, allowing control of two separate vehicles. Up to four remote
controls can be assigned to your vehicle.
NOTE: The range of your remote control can be affected by a weak battery, interference from nearby
metal structures, hydro poles, or crowded parking lots.
Only the "Panic" command is transmitted on both channels when a single command is sent
(alternating transmission channels).
The transmitter visual (LED ) confirmation.
The LED lights-up red when it transmits on channel one or green when it transmits on channel two.
The remote shown may differ from the one included in the kits.

SELECTING TRANSMISSION CHANNEL

CHANNEL 1 CHANNEL 2
Momentarily press the « » button, then as soon as a
Press desired button for two
tone is heard or that the red LED lights-up, press the
seconds.
desired button and hold it down for two seconds.
A command will not be executed if you do not press button long enough.
Only one command is transmitted even when a button is pressed for more than two seconds, except for the "Panic"
command, which is repeated as long as button is pressed.
Your system may be programmed in such a way that it can distinguish between two groups of remote controls (maximum:
two remotes per group). These groups let you activate predefined settings (seat, mirror and other) when unlocking certain
vehicles (additional optional equipment required).

BATTERY REPLACEMENT

Your remote works off one 3-volt lithium CR-2032 battery or equivalent.
To replace the battery, open the remote casing, remove old battery and replace
it a new one.
Make sure to properly orient the battery; see illustration opposite.
Close the casing.
9