Pager - AstroStart RSS-5224 Manuel De L'usager

REMOTE CONTROL SETTING
Certain functions on the remote may be set to your convenience.
To access the remote control programming mode, press the
seconds.
The remote beeps once to indicate entering programming mode.
R
EMOTE TRANSMITTER PROGRAMMING TABLE
P S
ARAMETERS ETTINGS
Lock
Keyboard Un/Lock
Unlock
Disabled
Mute
Enabled
Enabled
Status confirmations
Disabled
Trunk
Motion sensor
Auxiliary sensor icon Glass breakage sensor
Tilt sensor
Ultrasonic sensor
Upon "Status" command
Back-light Upon any command
Never
Number of vehicle 1 – 4 (Default setting : 2)
L : DISPLAYED ICON (BLACK) : MASKED ICON (GRAY) :
EGEND

PAGER

The system is equipped with a function called 'Pager'. The purpose of this function is to send a general call asking those
who carry them to get to the vehicle or to perform a task previously established.
Paging
To send a general call, the user must press the 'Valet' switch and hold it for 3 seconds while engine is stopped and key is
not in the ignition, or while engine is remote started (see 'Valet Mode' on page 17)(The valet switch is a small push button
hided under the dash board).
Parking lights on the vehicle blink once to confirm the call was sent.
All remote controls (maximum: 4) located within the radio frequency range of the vehicle will begin to chirp. To silence the
remote control, press any button.
8
button located on the back of the remote and hold it for 5
B D / R
UTTONS ISPLAY EMARKS
/ 1
BEEP
/ 2
BEEPS
/ 1
BEEP
/ 2
BEEPS
/ 1
BEEP
/ 2
BEEPS
1
BEEP
2
BEEPS
3
BEEPS
4
BEEPS
5
BEEPS
T -
HE DISPLAY LIGHTS UP
3
FOR SECONDS
-
BACK LIGHT SHUTS OFF
1 2 3 4
DEFAULT SETTING