AstroStart RSS-5224 Manuel De L'usager page 31

CONFIRMATIONS EMITTED BY THE REMOTE
An audible confirmation (piezo) and a visual confirmation (LCD display) are emitted each time a command is transmitted.
The LCD displays the vehicule status at all time, the display is refreshed on every transmission or when the status of the
vehicle changes pertaining that the "Status confirmation" function is enable. The display shows the last confirmation
received.
The following diagram shows the usefulness of each icon of the display.
Descriptions in CAPITAL letters show confirmations pertaining to the security system's functions.
1 Transmission
1 2 3 4 5 6
2 Vehicle out of range
7
3 Reception
8
25
4 Unlocking
9
24 5 Locking
10
23 6 PRE-ALERT
MD
22
11
7 Panic / PRE- ALERT
21
12
8 ALARM
20
13
9 SHOCK SENSOR
19
10 FEILD DISTURBANCE SENSOR
18
11 TRUNK LID STATUS
14
17
12 GLASS BREAKAGE SENSOR
16 15
13 DOORS STATUS
Two types of confirmations are displayed on the remote :
Command confirmation: These confirmations are command acknowledgement, the icon corresponding to the command is
displayed to confirm reception of the command.
Status confirmations : These confirmations are displayed when the status of a zone, monitored by the system, changes.
i.e. : door opening, security system alarm state, etc.
Command confirmations are returned immediately following a command transmission whereas the status confirmations may
be returned up to 12 seconds after the event appended depending on the communication protocol between the hand-held
unit and the vehicle.
Remarks: When the remote receives a confirmation that is intended to a vehicle other that the one actually selected, most
audible confirmations are made more discrete, vehicle icon flashes (1-4) to warn you that the display reflect the status of that
specific vehicle.
When a command is transmitted, the vehicle selection gets back to the previously selected unless the confirmation was
related to an alarm condition.
In that case the selected vehicle is temporarily changed, to allow stopping the alarm condition without having to change the
vehicle selection, then gets back to previously selected when the alarm condition is stopped.
Out of range : In the event that the environment prevents the confirmation from being received by the remote control, all
icons are cleared out. In this case, resend the command or send the status command to refresh the display.
14 Battery charge indicator
15 Auxiliary outputs status
16 Sentinel mode status
17 SECURITY SYSTEM STATUS
18 ULTRASONIC SENSOR
19 IGNITION STATUS SENSOR
MD 20 TILT SENSOR
/ ALARM
21 Remote starter status
22 HOOD STATUS
23 TRIGGERED ZONES
24 Valet mode status
25 Vehicle identification
7
Commentaire [c2]: Verifier le terme.
Commentaire [c3]: Traduction