Publicité
Les langues disponibles
Les langues disponibles
5. Repeat for the remaining two wires.
6. To attach the solid-core pigtail to the mounting plate, strip 5/8
in. of insulation from the other end of the solid-core wire. Use
the wire length measuring guide on the back of the mounting
plate to ensure the correct wire length (see Figure 3).
7. Insert the pigtail wires into the side of the terminal block on the
back of the mounting plate (see Figure 4).
• Insert the white pigtail wire into the terminal marked "N".
• Insert the black pigtail wire into the terminal marked "L".
• Insert the bare or green ground pigtail wire into the terminal
marked "G".
FINAL ASSEMBLY
NOTICE: The light fixture must securely snap onto the mounting
plate completely for the locking handle to close.
IMPORTANT: Use the larger mounting plate screws if the pre-installed
screws are too small for the junction box holes.
• Unscrew the mounting plate screws from the mounting plate
using a screwdriver.
• Remove the rubber gaskets from the mounting plate screws.
• Place the rubber gaskets on the larger mounting plate screws and
screw the screws into the mounting plate using a screwdriver.
1. Place the mounting plate against the junction box and tighten the
two mounting screws securely to the junction box (see Figure 5).
If necessary, use the screws that were removed from the existing
light fixture. Do not overtighten.
2. Firmly pull on the mounting plate to ensure it is securely attached
to the junction box.
IMPORTANT: During the installation, DO NOT press against the
light panels or the heat sinks. Move the light panels apart and apply
pressure directly to the light fixture housing (see Figure 6).
3. Pull up on the locking handle to unlock.
4. Align the back of the light fixture with the mounting plate.
5. Firmly press the center of the light fixture housing to securely
snap the light fixture onto the mounting plate. The light fixture
must be fully seated onto the mounting plate all the way around.
6. Rotate the light fixture to the desired position.
7. Press down on the locking handle completely to secure the light
fixture to the mounting plate (see Figure 7).
NOTICE: Gently pull on the light fixture to ensure it is securely
connected to the mounting plate.
4
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 5
Figure 6
Figure 7
210509-01
Publicité
