Scubapro Module Light Manuel page 6

NOTE: Always check o-rings (30.200.122 / 30.200.126 / 30.200.127) before
use; grease and/or replace if necessary.
Extra tips:
Do not over-tighten the parts.
Keep bulbs dry and protected from shocks while stored.
We recommend changing the O-rings when mounting a new light head. Use
O-ring kit (30.200.134) for all module combinations.
SCUBAPRO Module Light - Warranty
SCUBAPRO Module Light has a general warranty coverage of three years on
technical parts and one year for the battery/battery pack, with proof of purchase
from an authorized SCUBAPRO dealer. All warranty claims must be returned
with dated proof-of-purchase to an Authorized SCUBAPRO Dealer. Visit
www.scubapro-uwatec.com for the dealer nearest you.
Warranty does not cover:
- Loss.
- Defects, damage or deterioration due to normal use or wear and tear.
- Bulbs and glass.
- Damage caused by exposure to excessive heat, prolonged sunlight or
corrosive chemicals.
- Damage due to poor maintenance, improper use, alteration, negligence or
accident.
- Damage due to repair by someone other than SCUBAPRO or an Authorized
SCUBAPRO Dealer.
The owner commits to using the product according to the instruction manual and
to maintaining it with care. We recommend servicing your new Module Light at
authorized SCUBAPRO dealers or service centers. Irrespective of any damage
that may be incurred, the warranty is limited to the repair or possible replacement
of the SCUBAPRO Module Light.
SCUBAPRO Module Light - Technical information
Burn time at 20° C (minutes)
Power (Watts)
Beam width (degrees)
Bulb life (hours)
Weight in air (grams)
Weight underwater (grams)
Colour temperature (Kelvin)
Module Battery Pack
Length (mm)
Diameter (mm)
Weight in air (grams)
Weight underwater (grams)
Voltage
Capacity
IRC Xenophot
70 80
35 30
24 24
4,000 50
280 240
135 95
3,600 3,800
Battery pack
235
60.3
1015
310
12V
4.5Ah
LED HID
330 240
9 (40) 10 (50)
20 24
100,000 1,000
300 400
155 165
5,500 6,200
Umbilical
1,000
475
300
5