Rauch KUHN RV 2M 1 Notice De Montage page 20

Assembly Instructions
RV 2M 1 Row Spreading Unit
 The width of the spreading band can be changed by adjusting the side plate (Pho-
to 5).
 Due to the small spreading width the disc vanes must only be set in position A1 -
A1. Under no circumstances should the disc vanes be extended otherwise they
will foul the row spreading unit.
 After fitting the row spreading unit revolve the discs by hand to make sure nothing
fouls.
 Raising and lowering the unit will produce small variations in the width setting
available on the row spreading unit.
 Application rates can be proportionally calculated from data in the spreading chart
to suit effective spreading widths.
Example:
Driving speed (km/h) x 2 (m) x application rate (kg/ha) = nominal discharge quantity (kg/min)
The metering slide opening has to be determined by a calibration test.
5900193-b-de/fr/en-0311
Photo 5
600
20 R.K.