Hilti C 4/12-50 Mode D'emploi page 11

Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
4 Technical data
Weight
Output voltage
Output power
5 Operation
5.1 Switching the charger on
▶ Plug the supply cord into the power outlet.
➥ LED 1 on the charger lights up green.
5.2 Charging the battery
1. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
➥ A list of the batteries approved for use with this product can be found
at the end of this document.
2. Push the battery into the interface of the charger. Check that the encoding
of the battery and charger interface match.
➥ Charging begins automatically after insertion of the battery in the
charger. The state of charge indicator on the battery is deactivated
during charging.
The battery will suffer no damage when left in the charger for long
periods.
For safety reasons, the battery should, however, be removed from
the charger after completion of charging.
5.3 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.
*2081391*
Printed: 03.01.2019 | Doc-Nr: PUB / 5170421 / 000 / 06
C 4/12-50
0.35 kg
10.8 V
50 W
2081391 English 7