Hoover ONE PWR SYSTEM FLOORMATE JET Mode D'emploi page 12

CLEANING THE BRUSH ROLL AND NOZZLE (CONT.)
1
After rinsing, remove the nozzle
cover by squeezing the latches
and lifting up.
12
2 3
Lift up on the tab to remove the If needed, rinse brush roll cover
brush roll. Place in rack on and wipe any remaining residue
storage tray and allow to dry from the brush roll chamber
completely before reinstalling. and hose. Allow to dry before
returning to the cleaner.
4 5
To reassemble, align brush roll Replace brush roll cover. Ensure
onto the gear and lock into place that the corners are down and
by pressing down on the tab end. the brush roll cover is fully in
place.