Lanaform Bali Manuel D'instructions page 9

TROUBLESHOOTING
In the event of a malfunction, under normal conditions of use, please refer to the following chart:
Problem
No steam, no light indicators
Mist has an unusual smell
Low intensity
ADvICE REGARDING THE DISPOSAL OF wASTE:
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at your local sorting centre to be used as secondary raw
materials. The cardboard may be disposed of in a paper recycling bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with the law.
LIMITED wARRANTy
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the date of purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the guarantee covering this LANAFORM® product does not cover
damage caused by abusive or inappropriate or incorrect use, accidents, the use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort,
that is outside LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage. All implicit guarantees relating to the suitability of the product are limited to a period of
two years from the initial date of purchase as long as a copy of the proof of purchase can be supplied.
On receipt, LANAFORM® will repair or replace your appliance at its discretion and will return it to you. The guarantee is only valid through LANAFORM®'s Service Centre®. Any attempt to
maintain this product by a person other than LANAFORM®'s Service Centre will render this guarantee void.
EN
Possible causes
If there is no light.
The water level in the reservoir is too low.
The temperature of the unit is too low.
The water has been standing in the reservoir too long.
Too much/little water in the reservoir.
Sediment on the transducer.
The water is too cold.
The water is not clean.
10
Solution
Check the mode chosen. If you chose continuous diffusion
with ambient light, check that the device is plugged in
and no power outage has occurred.
Add water to the reservoir.
Place the unit in a room at ambient temperature for half
an hour prior to use.
Clean the reservoir and pour fresh water into it.
Empty the water out of the reservoir or add water to it.
Clean the transducer.
Use water that is at room temperature.
Clean the reservoir and pour fresh water into it.