HIKOKI CG 36DB Mode D'emploi page 7

SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CG36DB / CG36DB(L):
Cordless Grass Trimmer
To reduce the risk of injury, user must
read instruction manual.
Always wear eye protection.
Always wear hearing protection.
Do not use a power tool in the rain and
moisture or leave it outdoors when it is
raining.
Keep bystanders away.
Remove battery before adjusting or
cleaning and before leaving the machine
unattended for any period.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
It is important that you read, fully understand
and observe the following safety precautions
and warnings. Careless or improper use of the
unit may cause serious or fatal injury.
Read, understand and follow all
warnings and instructions in this manual
and on the unit.
Prohibited action
Always wear eye, head and ear
protectors when using this unit.
Keep all children, bystanders and
helpers 15 m away from the unit. If
anyone approaches you, stop the unit
and cutting attachment immediately.
Be careful of thrown objects.
Shows maximum shaft speed. Do not
Max use the cutting attachment whose max
8,000 min
-1
rpm is below the shaft rpm.
Gloves should be worn when necessary,
e.g., when assembling cutting
equipment.
Use anti-slip and sturdy footwear.
(Original instructions)
WHAT IS WHAT? (Fig. 1)
A: Lever: Trigger for activating the unit.
B: Lock lever: Lever that prevents the accidental operation
of the trigger.
C: Motor: Battery-driven motor.
D: Guard: Protects operator from fl ying debris.
E: Battery (sold separately): Power source to drive the unit.
F: Power switch: Switch for switching the units power unit's
power ON or OFF.
G: Mode switch: Switch for adjusting the speed of the
motor.
H: Handle right: Handle with lever located on the right side
of the unit.
I: Handle left: Handle located on the left side of the unit.
J: Handle fi xture: Secures the handles to the unit.
K: Hanger: Used for attaching a shoulder belt to the unit.
L: Loop handle
M: Shoulder belt: Harness with release mechanism.
7
Blade thrust may occur when the
spinning blade contacts a solid object in
the critical area. A dangerous reaction
may occur causing the entire unit and
operator to be thrust violently. This
reaction is called blade thrust. As a
result, the operator may lose control of
the unit which may cause serious or fatal
injury. Blade thrust is more likely to occur
in areas where it is diffi cult to see the
material to be cut.
Power switch
Switching on
Switching off
Mode switch
Eco mode
Normal mode
Power mode
English