Blumfeldt Venice Heat Stand Mode D'emploi page 17

Fix the power cord to the base by 2 pcs ST6*14 mm screws.
OPERATION
• Connect the power cable to a power socket that is located in a safe, dry
area.
• The rocker power switch in the heater head is used to control the two heat
settings. 1 = 1000 W, 2 = 2000 W.
• Although the heater is shower proof, do not use when raining or in wet
conditions.
• Always disconnect the power cable from the electrical supply, when the
heater is not in use.
CLEANING AND CARE
• When disconnected from the power supply, clean the outside of the
infrared heater with a damp cloth.
• Never use corrosive or solvent cleaners or immerse in water.
• Any maintenance or repairs including replacing the halogen tube should
only be carried out by a qualified electrician or by a recommended service
centre.
5
EN
17