Astralpool Viron P320 eVo Instructions D'installation Et De Fonctionnement page 12

OPERATION OF CONTROL PANEL – VIRON P320 & P600 EVO (CONT...)
Using the in built timer to operate pump with an AstralPool Chlorinator or e-Quilibrium dosing unit
Factory Default Setting
1. The inbuilt timers are activated and will control the time the pump operates.
2. Connectivity to AstralPool compliant Salt Chlorinators, e-Quilibrium Chemical dosing controllers or Viron
Connect remote Controls is turned "off".
3. Use the "auto" button to turn the pump on or off. When in on position, the pump will remain off until
the next timer period unless pressed again to manually on. If pump is turned to manually on, it will
continue to operate indefinitely. If in the "Off" position (visible on the LCD), the pump will remain
indefinitely off. For timer operation, ensure the "auto" button is pressed so that the LCD screen displays
"auto".
Setting the current Time
1. If connected to a compliant AstralPool Salt Chlorinator or e-Quilibrium dosing controller connect data
cable between rear of pump and the chlorinator in e-Quilibrium dosing unit.
2. Connect and turn power on to the pump and Chlorinator (or dosing unit).
3. Toggle MENU (twice) until "CLK" appears and press ENTER to set time. Use
set the hour, press ENTER again to set minutes and then press ENTER again to set AM or PM.
4. Press ENTER to accept.
5. The LCD screen will quickly flash 3 times to indicate the new setting has been accepted.
Setting pump to operate independently of external AstralPool Compliant Chlorinator or Control System
1. Toggle MENU until "CONF" is displayed on the LCD screen.
2. Press and HOLD ENTER for 3 seconds. "TMRS" will appear.
3. Press ENTER.
4. Press UP or Down buttons to turn "TMRS" on.
5. Press ENTER to accept.
6. Press "auto" to return to main menu.
Changing Low, Med and High Speed Settings
1. Select the Speed Button to be adjusted, Low, Medium or High. Respective LED will light up.
2. Alter the speed in increments of 25 RPM using the up and down arrows until the desired speed is
displayed on the screen. Respective "Speed 1", "Speed 2" or "Speed 3", will flash while editing.
3. The new speed will automatically save after 2 seconds. Flashing will stop to signal save.
Setting filtration timer periods
1. Press MENU to go to PRIM setting.
Installation and General Maintenance Manual – Viron eVo Pool Pump
up and down arrows to
12